Deep groove ball bearing belongs to the precision part, so it requires a very cautious attitude when it is used, that is, the high performance bearing is used. If it is not used properly, it will not achieve the expected performance effect, and it will easily damage the bearing. Therefore, the use of bearings should pay attention to the following items:
1. Keeping the bearing and its surrounding environment clean, even if the unseen smile dust enters the bearing, it will also increase the wear, vibration and noise of the bearing.
Two, the use of installation should be careful, not allowed to force punching, not allowing the hammer to strike the bearings directly, and not to pass the pressure through the rolling body.
Three, use appropriate and accurate installation tools, try to use special tools, and try to avoid the use of cloth and short fiber.
Four, prevent corrosion of bearings. When directly carrying the bearings by hand, wash the sweat on hand and wash it with high quality mineral oil. Then we should pay special attention to rust prevention in rainy season and summer season. However, under some special operating conditions, the bearing can get longer than the traditional computing life, especially in light load conditions. These special operation conditions are that the rolling surface (track and rolling part) is effectively separated by a lubricating oil film and the surface damage caused by pollutants can be restricted. In fact, under ideal conditions, the so-called permanent bearing life is possible.
1. Keeping the bearing and its surrounding environment clean, even if the unseen smile dust enters the bearing, it will also increase the wear, vibration and noise of the bearing.
Two, the use of installation should be careful, not allowed to force punching, not allowing the hammer to strike the bearings directly, and not to pass the pressure through the rolling body.
Three, use appropriate and accurate installation tools, try to use special tools, and try to avoid the use of cloth and short fiber.
Four, prevent corrosion of bearings. When directly carrying the bearings by hand, wash the sweat on hand and wash it with high quality mineral oil. Then we should pay special attention to rust prevention in rainy season and summer season. However, under some special operating conditions, the bearing can get longer than the traditional computing life, especially in light load conditions. These special operation conditions are that the rolling surface (track and rolling part) is effectively separated by a lubricating oil film and the surface damage caused by pollutants can be restricted. In fact, under ideal conditions, the so-called permanent bearing life is possible.
